NEC Univerge SV8100 System Hardware Manual page 122

UNIVERGE SV8100
Initial Blade
Blade Blade
Slot #
1 CD-16DLCA
2 CD-8DLCA
(no daughter board)
3 CD-16DLCA
-
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
Table 4-1 Extension Blade Installation Order Example
Order of
Installation
1
2
3
4
After the initial powering up of the system, subsequent powering up or
resets do not change the slot identification. System programming
(Program 90-05) must be performed to change the slot identification.
Adding any daughter board to increase the available ports or go to a
higher capacity blade (e.g., CD-16DLCA) may require that the slot be
deleted in programming and the blade reinstalled. In the following
example, to add a daughter board to slot 2, the blade must be removed,
deleted in Program 90-05-01, then reinstalled with the daughter board
attached, otherwise the additional ports are not recognized. This however,
uses new ports for the combined blade -the initial ports (ports 17~24 using
the example below) are not used.
Table 4-2 Adding Daughter Board to Chassis Example
Extension
Numbers
200~215
216~223
224~239
- -
The system automatically recognizes each blade installed in the system. If
a blade has previously been installed in a slot and another type of
blade is to be installed in that same slot, the blade must first be removed
from the chassis and then the slot definition removed using Program
90-05 prior to installing the new blade. This same condition applies to
extensions and other devices connected to the system. For example, if a
port was previously used for a telephone and a DSS Console is to be
installed in that same port, it must first be undefined in Program 10-03
before the console is connected.
Blade Slot
Number
1 CD-16DLCA
2 CD-16DLCA
4 CD-8DLCA
PZ-8LCE
3 CD-8DLCA
Blade
Slot #
1 CD-16DLCA
2
3 CD-16DLCA
4 CD-8DLCA
(w/ daughter board)
http//vietpro.com.vn
Extension
Blade
Numbers
200~215
216~231
232~247
248~255
Updated Blade
Blade Extension
Numbers
200~215
-
224~239
240~255
-
4-5