Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

8.3.2

Communication detail settings

Make the settings according to the usage environment.
Item
GOT Net No.
GOT Station
GOT Communication Port No.
Delay Time
32bit Storage
8.3.3 GOT Ethernet Setting
The GOT can be connected to a different network by configuring the following setting.
■1. GOT IP address setting
Set the following communication port setting.
• Standard port (When using GT25-W, port 1)
• Extension port (When using GT25-W, port 2)
■2. GOT Ethernet common setting
Set the following setting which is common to the standard port and the extension port, or port 1 and port 2.
• [Default Gateway]
• [Peripheral S/W Communication Port No.]
• [Transparent Port No.]
■3. IP filter setting
By configuring the IP filter setting, the access from the specific IP address can be permitted or shut off.
For the detailed settings, refer to the following manual.
➠ 1.1.2 GOT Ethernet Setting
Description
Not used
Not used
Set the GOT port No. for the connection with the Ethernet module.
(Default: 502)
Set the delay time for reducing the load of the network/destination PLC.
(Default: 0ms)
Select the steps to store two words (32-bit data).
(Default: LH Order)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Range
-
-
502 to 65534
(Except for 503 to 1023, 5011 to 5013 and
49153 to 49170)
0 to 10000(×10ms)
LH Order/HL Order
8.3 GOT Side Settings
8
8 - 5