Got Ethernet Setting - Mitsubishi Electric GOT2000 Series Connection Manual

3.5.3

GOT Ethernet Setting

The GOT can be connected to a different network by configuring the following setting.
■1. GOT IP address setting
Set the following communication port setting.
• Standard port (When using GT25-W, port 1)
• Extension port (When using GT25-W, port 2)
■2. GOT Ethernet common setting
Set the following setting which is common to the standard port and the extension port, or port 1 and port 2.
• [Default Gateway]
• [Peripheral S/W Communication Port No.]
• [Transparent Port No.]
■3. IP filter setting
By configuring the IP filter setting, the access from the specific IP address can be permitted or shut off.
For the detailed settings, refer to the following manual.
➠
1.1.2 GOT Ethernet Setting
POINT POINT POINT
Special Interrupt Code
The following shows the compatibility between the special interrupt codes and the event types.
Special Interrupt Code
(Hex)
Base Screen
Output when the screens are switched according to the change in the switching device values
assigned to 1/2.
20H
*1:Base Screen or Overlap Window 1/2 switches independently without being interlocked.
(Example of output)
When all the switching device values assigned to the Base Screen and Overlap Window1/2 are
changed, 3 special interrupt codes are output.
21H Output when Numerical/ASCII Input is completed.
22H Output when Recipe data transfer (read-out, write-in) is completed.
23H Output when Bar code, RFID data has been imported into GOT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Event type
*1 *1
and Overlap Window
3.5 GOT Side Settings
3
3 - 71