Step2 Setting The Got Mobile Function - Mitsubishi Electric GOT2000 Series Quick Start Manual

Using the GOT Mobile Function
STEP2
Setting the GOT Mobile function

STEP2 Setting the GOT Mobile function

With the GOT Mobile function, the GOT acts as the server and the information device such as a tablet acts
as a client.
The connected device can be monitored from the client via the server (GOT).
1. Enable the GOT Mobile function
2. Items to check before setting the authentication setting
(1) Check the GOT unit's CoreOS version.
Check that the GOT unit's CoreOS version is Version L or later.
For the procedure to check the version, refer to the following manual.
GOT2000 Series User's Manual (Utility) (SH-081195ENG)
(2) If the GOT unit's CoreOS version is not Version L or later
The CoreOS Version L or later must be written to the GOT using GT Designer3 Ver. 1.144A or later.
For the CoreOS writing methods, refer to the following manual.
GT Designer3 (GOT2000) Help
(To display a Help page corresponding to the operation status of GT Designer3, press [F1] key while
operating GT Designer3.)
10 Setting the GOT Mobile function
2
3
4
Click [Common] → [GOT Mobile Setting].
1
Select [Use GOT Mobile function].
2
Set [Simultaneous Client Connection] to the default
3
value [2].
Do not check [Use any port No. other than the
4
standard port No. (80)]. Use the port No. [80].
Simultaneous client connection
Set the number of information devices
(clients) such as tablets to connect.
Up to five units can be set for one GOT.