Advertisement
S3C8248/C8245/P8245/C8247/C8249/P8249
LCD DRIVE VOLTAGE
The LCD display is turned on only when the voltage difference between the common and segment signals is
greater than V
. The LCD display is turned off when the difference between the common and segment signal
LCD
voltages is less than V
selected signals of the bias. Table 14-7 shows LCD drive voltages for static mode, 1/2 bias, and 1/3 bias.
LCD Power Supply
V
LC2
V
LC1
V
LC0
V
ss
NOTE: The LCD panel display may deteriorate if a DC voltage is applied that lies between the common and segment signal
voltage. Therefore, always drive the LCD panel with AC voltage.
LCD SEG/SEG SIGNALS
The 32 LCD segment signal pins are connected to corresponding display RAM locations at 00H–0FH.
Bits 0-3 (and 4-7) of the display RAM are synchronized with the common signal output pins COM0, COM1,
COM2, and COM3.
When the bit value of a display RAM location is "1", a select signal is sent to the corresponding segment pin.
When the display bit is "0", a 'no-select' signal is sent to the corresponding segment pin. Each bias has select
and no-select signals.
FR
COM
SEG
COM-SEG
Figure 14-4. Select/No-Select Bias Signals in Static Display Mode
The turn-on voltage, + V
LCD.
Table 14-6. LCD Drive Voltage Values
Static Mode
V
0 V
Select
1 Frame
or - V
, is generated only when both signals are the
LCD
LCD
LCD
–
–
LCD CONTROLLER/DRIVER
1/2 Bias
V
LCD
V
LCD
1/2 V
LCD
0 V
Non-Select
1/3 Bias
V
LCD
2/3 V
LCD
1/3 V
LCD
0 V
V
LC2
V
SS
V
LC2
V
SS
V
LC2
V
SS
-V
LC2
14-7
Advertisement
