Advertisement
S3C8248/C8245/P8245/C8247/C8249/P8249
BASIC TIMER FUNCTION DESCRIPTION
Watchdog Timer Function
You can program the basic timer overflow signal (BTOVF) to generate a reset by setting BTCON.7–BTCON.4 to
any value other than "1010B". (The "1010B" value disables the watchdog function.) A reset clears BTCON to
"00H", automatically enabling the watchdog timer function. A reset also selects the CPU clock (as determined by
the current CLKCON register setting), divided by 4096, as the BT clock.
The MCU is reseted whenever a basic timer counter overflow occurs, During normal operation, the application
program must prevent the overflow, and the accompanying reset operation, from occuring, To do this, the
BTCNT value must be cleared (by writing a "1" to BTCON.1) at regular intervals.
If a system malfunction occurs due to circuit noise or some other error condition, the BT counter clear operation
will not be executed and a basic timer overflow will occur, initiating a reset. In other words, during the normal
operation, the basic timer overflow loop (a bit 7 overflow of the 8-bit basic timer counter, BTCNT) is always
broken by a BTCNT clear instruction. If a malfunction does occur, a reset is triggered automatically.
Oscillation Stabilization Interval Timer Function
You can also use the basic timer to program a specific oscillation stabilization interval after a reset or when stop
mode has been released by an external interrupt.
In stop mode, whenever a reset or an external interrupt occurs, the oscillator starts.. The BTCNT value then
starts increasing at the rate of fxx/4096 (for reset), or at the rate of the preset clock source (for an external
interrupt). When BTCNT.4 overflows, a signal is generated to indicate that the stabilization interval has elapsed
and to gate the clock signal off to the CPU so that it can resume the normal operation.
In summary, the following events occur when stop mode is released:
1. During the stop mode, a power-on reset or an external interrupt occurs to trigger the Stop mode release and
oscillation starts.
2. If a power-on reset occurred, the basic timer counter will increase at the rate of fxx/4096. If an interrupt is
used to release stop mode, the BTCNT value increases at the rate of the preset clock source.
3. Clock oscillation stabilization interval begins and continues until bit 4 of the basic timer counter overflows.
4. When a BTCNT.4 overflow occurs, the normal CPU operation resumes.
BASIC TIMER
10-3
Advertisement
