Advertisement
S3C8248/C8245/P8245/C8247/C8249/P8249
DJNZ
— Decrement and Jump if Non-Zero
DJNZ
r,dst
r ← r – 1
Operation:
If r ≠ 0, PC ← PC + dst
The working register being used as a counter is decremented. If the contents of the register are
not logic zero after decrementing, the relative address is added to the program counter and
control passes to the statement whose address is now in the PC. The range of the relative
address is +127 to –128, and the original value of the PC is taken to be the address of the
instruction byte following the DJNZ statement.
NOTE: In case of using DJNZ instruction, the working register being used as a counter should be set at
Flags:
No flags are affected.
Format:
r | opc
Example:
Given: R1 = 02H and LOOP is the label of a relative address:
SRP
DJNZ R1,LOOP
DJNZ is typically used to control a "loop" of instructions. In many cases, a label is used as the
destination operand instead of a numeric relative address value. In the example, working register
R1 contains the value 02H, and LOOP is the label for a relative address.
The statement "DJNZ R1, LOOP" decrements register R1 by one, leaving the value 01H.
Because the contents of R1 after the decrement are non-zero, the jump is taken to the relative
address specified by the LOOP label.
the one of location 0C0H to 0CFH with SRP, SRP0, or SRP1 instruction.
dst
#0C0H
Bytes
Cycles
2
8 (jump taken)
8 (no jump)
INSTRUCTION SET
Opcode
Addr Mode
(Hex)
dst
rA
RA
r = 0 to F
6-39
Advertisement
