Using Rarp - Canon imageRUNNER 2545i System Settings Manual

● Using DHCP:
❑
Press [DHCP].
❑
Enter the IP address, subnet mask, and gateway address.
If this information cannot be obtained via DHCP after you restart the machine, the
settings entered in this step are used.
● Using RARP:
❑
Press [RARP].
❑
Enter the IP address, subnet mask, and gateway address.
If this information cannot be obtained via RARP after you restart the machine, the
settings entered in this step are used.
● Using BOOTP:
❑
Press [BOOTP].
❑
Enter the IP address, subnet mask, and gateway address.
If this information cannot be obtained via BOOTP after you restart the machine, the
settings entered in this step are used.
NOTE
• Only one of the DHCP, BOOTP, or RARP settings can be selected at any one time.
• Even if you press [DHCP], [BOOTP], or [RARP], enter an IP address, subnet mask,
and gateway address. If this information cannot be obtained from the DHCP, BOOTP,
or RARP server, the settings entered in this step are used.
• If the machine is restarted after DHCP, BOOTP, or RARP settings are complete, the
TCP/IP Settings screen displays the IP address setting values obtained from the
DHCP, BOOTP, or RARP server. (If the IP address, host name, and domain name
have been previously set, these will be overwritten by the setting values obtained from
DHCP, BOOTP, or RARP.)
• If you use DHCP without the DNS dynamic update function, it is recommended that an
identical IP address be assigned to the machine at all times. (If the IP address is not
identical, the host name for the machine will not be able to correspond to the IP
address.)
• It takes about two minutes to check whether the DHCP, BOOTP, or RARP settings can
be used. If you do not plan to use one of these settings, it is recommended that you
turn them off.
4
Confirm the settings you specified ➞ press [OK].
5
Restart the machine.
Turn OFF the machine, wait at least 10 seconds, and then turn it ON.
Specifying the Machine's IP Address
2
2-17