Toshiba GD-1370 Fax Manual page 27

2.USING THE FAX UNIT (BASIC OPERATION)
 When an original of any size other than LT/A4 is placed in the direction shown in the above left
figure, transmission to a recipient is carried out so that the pre-entered sender information is
printed in position A in the figure.
 When an original of LT/A4 size is placed in the direction shown in the above right figure,
transmission to a recipient is carried out so that the pre-entered sender information is printed
in position B in the figure.
 The pre-entered sender information shows what is registered in the Terminal ID.
For details about the registration method of the Terminal ID, refer to the MFP Management
Guide.
Placing 2-sided originals
To set 2-sided originals of the LT/A4 size, change their direction depending on their bound positions as
follows.
1. Right-to-left (book-type) original
2. Top-to-bottom (tablet-type) original
1
When sending a 2-sided original, it is necessary to select the 2-sided setting as the transmission
condition.
 P.33 "Setting the transmission conditions"
A
B
2
Operating the Fax unit 27