Toshiba GD-1370 Fax Manual page 26

2.USING THE FAX UNIT (BASIC OPERATION)
Align the original against the left inner corner of the glass.
2
 Different size originals can also be sent in one transmission.
 When an original of any size other than LT/A4 is placed in the direction shown in the above left
figure, transmission to a recipient is carried out so that the pre-entered sender information is
printed in position A in the figure.
 When an original of LT/A4 size is placed in the direction shown in the above right figure,
transmission to a recipient is carried out so that the pre-entered sender information is printed
in position B in the figure.
 The pre-entered sender information shows what is registered in the Terminal ID.
For details about the registration method of the Terminal ID, refer to the MFP Management
Guide.
Lower the original cover or ADF slowly.
3
 Placing the original(s) on the ADF
This section describes how to set the original(s) on the ADF. When the originals are placed on the RADF,
the uppermost page is the first to be scanned and sent.
After aligning the originals, place them with their face up and slide the guides to rest
1
against the edges of the originals.
 When the DSDF (Dual Scan Document Feeder) is used:
Regardless of the paper size, originals are acceptable up to 300 sheets (35 to 80 g/m
lb. Bond)) or 38 mm (1.50") in height.
 When the RADF (Reversing Automatic Document Feeder) is used:
Regardless of the paper size, originals are acceptable up to 100 sheets (35 to 80 g/m
lb.)) or 16 mm (0.62") in height.
 2-sided originals can be set and sent.
 P.33 "Setting the transmission conditions"
26 Operating the Fax unit
A
B
2
(9.3 to 20
2
(9.3 to 20