Servicing The Spark Plugs - Toro 74311TE Operator's Manual

g025138
Figure 41
3. Fill the crankcase with the proper type of new oil; refer
to Checking the Engine-Oil Level (page

Servicing the Spark Plugs

Service Interval: Every 500 hours—Check and gap the
Make sure that the air gap between the center and side
electrodes is correct before installing the spark plugs. Use a
spark-plug wrench for removing and installing the spark plugs
and a gapping tool/feeler gauge to check and adjust the air
gap. Install new spark plugs if necessary.
Type: Champion
Air Gap: 0.76 mm (0.030 inch)
Removing the Spark Plugs
1. Move the speed control lever to the neutral position
to stop the machine.
2. Disengage the PTO, engage the parking brake, stop the
engine, and wait for all moving parts to stop.
3. Remove the spark plugs.
Checking the Spark Plugs
Important: Replace the spark plugs when they have a
black coating, worn electrodes, an oily film, or cracks.
If you see light brown or gray on the insulator, the engine is
operating properly. A black coating on the insulator usually
means that the air cleaner is dirty.
Set the gap to 0.76 mm (0.030 inch).
35).
Installing the Spark Plugs
Tighten the spark plugs to 24.4 to 29.8 N-m (18 to 22 ft-lb).
37
spark plug.
® RC12YC or equivalent
Figure 42
2
1
Figure 43
G008794