Check And Clean The Hydraulic Pumps; Brake Maintenance; Adjusting The Parking Brake - Toro 74311TE Operator's Manual

Check and Clean the Hydraulic
Pumps
Service Interval: Before each use or daily
1. Move the speed-control lever to the N
to stop the machine.
2. Disengage the PTO, engage the parking brake, stop the
engine, and wait for all moving parts to stop.
3. Unlatch the seat and tilt the seat forward. Refer to
Unlatching the Seat (page 22)
4. Clean the debris and grass from the hydraulic pumps.
5. Lower the seat.

Brake Maintenance

Adjusting the Parking Brake

position
Service Interval: After the first 100 hours
EUTRAL
Follow this procedure also whenever you remove or replace a
brake component.
1. Stop the machine and move the speed-control lever
2. Disengage the PTO, engage the parking brake, shut off
3. Release the parking brake.
4. Unlatch the seat and tilt the seat forward. Refer to
5. Check and ensure there is no slack between the park
6. If an adjustment is necessary, remove the clevis pin
1. Parking brake
2. Rotate yoke
3. Clevis pin
7. Measure the compressed spring length on both vertical
44
Every 500 hours thereafter
to the N position.
EUTRAL
the engine, and wait for all moving parts to stop.
Unlatching the Seat (page
brake handle and the linkage.
and rotate the linkage counterclockwise to lengthen or
clockwise to shorten.
Figure 54
spring assemblies. The spring should measure between
6 to 7 cm (2.35 to 2.85 inches). If necessary, adjust the
nut at the top of the vertical spring assembly to achieve
this distance.
22).
4. Speed control lever
5. Steering levers