Transporting The Machine - Toro 74311TE Operator's Manual

The drive wheel release valves are located on the top left,
front corner of hydrostatic pumps.
1. Move the speed-control lever to the N
to stop the machine.
2. Disengage the PTO, engage the parking brake, shut off
the engine, and wait for all moving parts to stop.
3. Unlatch the seat and tilt the seat up to gain access to
the pumps. Refer to
4. Rotate both release valves 1 turn counterclockwise to
release the drive system
hydraulic fluid to bypass the pump, enabling the wheels
to turn.
5. Disengage the parking brake before pushing the
machine.
Note: Do not tow the machine.
6. Rotate the valves clockwise to run the machine.
Note: Do not overtighten the valves.
EUTRAL
Unlatching the Seat (page
(Figure 28). This allows the
g034569
Figure 28

Transporting the Machine

Use a heavy-duty trailer or truck to transport the machine.
position
Ensure that the trailer or truck has all necessary brakes,
lighting, and marking as required by law. Please carefully read
all the safety instructions. Knowing this information could
help you, your family, pets, or bystanders avoid injury.
WARNING
22).
Driving on the street or roadway without turn
signals, lights, reflective markings, or a slow-moving
vehicle emblem is dangerous and can lead to
accidents, causing personal injury.
Do not drive the machine on a public street or
roadway.
1. If using a trailer, connect it to the towing vehicle and
connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Shut off the engine, remove the key, set the brake, and
close the fuel valve.
5. Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes down and outward from
the machine.
26