Installing The Mower Deck - Toro 74311TE Operator's Manual

With 122cm direct-collect cutting unit
Hide thumbs Also See for 74311TE:
Table of Contents

Advertisement

Lowering the Mower Deck to the Operating Position
(page
23).
Note: The mower deck will become heavier when
you remove the springs from the anchors. Lower the
mower deck carefully.
6. Remove the lynch pins at front of push arms on both
sides of the machine
Figure 76
1. Slide the push arm into the deck push-arm tube.
2. Secure the push pin arm with the lynch pin.
7. Loosen the bolts attached to the rubber guard
77).
1
Figure 77
1. Bolts
2. Rubber guard
8. Unlatch the seat and disconnect the drive shaft using
the quick coupler at the jackshaft
(Figure
76).
(Figure
2
g036545
(Figure
78).
1. Jackshaft
9. Pull the mower deck forward to remove it from the
machine.

Installing the Mower Deck

Important: Do not transport the machine without an
approved Toro front mount attachment.
1. Shut off the engine, wait for all moving parts to stop
and remove the key. Engage the parking brake.
2. Roll the mower deck up to the machine with the
discharge tube down, making sure that the deck springs
are located above the drive wheel and below the
console on each side.
3. Unlatch the seat and tilt the seat forward.
4. Install the l drive shaft onto the jackshaft
5. Align the mower deck push-arm tubes to machine
push-arms and push the mower deck rearward.
6. Secure the push arms with the lynch pins on the left
and right sides of the machine
7. Align the upper portion of the rubber guard and secure
it with the attached bolts
8. Release the mower deck locking pins on each side, raise
the mower deck to the service position and secure the
deck latch onto the hook. Refer to
Deck into Service Position (page
9. Install the springs onto the spring anchor pins under
the left and right consoles and secure it with a washer
and hairpin
(Figure
10. Un-latch the mower deck from the raised position,
slowly lower the mower deck to ground and lock the
deck-locking pins on each side. Refer to
Mower Deck to the Operating Position (page
56
Figure 78
2. Drive shaft
(Figure
(Figure
76).
(Figure
77).
Raising the Mower
22).
75).
Lowering the
78).
23).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master 8000 series

Table of Contents