Toro 74311TE Operator's Manual page 34

1. Air-cleaner body
2. Primary filter
3. Latch
7. Remove the safety filter only if you intend to replace it.
Important: Do not attempt to clean the safety
filter. If the safety filter is dirty, then the primary
filter is damaged. Replace both filters.
8. Inspect the primary filter for damage by looking into
the filter while shining a bright light on the outside of
the filter. Holes in the filter will appear as bright spots.
If the filter is damaged, discard it.
Servicing the Primary Filter
•
If the primary filter is dirty, bent, or damaged, replace it.
•
Do not clean the primary filter.
Servicing the Safety Filter
Replace the safety filter, never clean it.
Important: Never attempt to clean the safety filter.
If the safety filter is dirty, then the primary filter is
damaged. Replace both filters.
Installing the Filters
Important: To prevent engine damage, always operate
the engine with both air filters and cover installed.
1. If installing new filters, check each filter for shipping
damage. Do not use a damaged filter.
2. If the inner filter is being replaced, carefully slide it into
the filter body (Figure
3. Carefully slide the primary filter over the inner filter
(Figure 37).
Note: Ensure that the primary filter is fully seated by
pushing on its outer rim while installing it.
Figure 37
4. Air-cleaner cover
5. Safety filter
37).
Important: Do not press on the soft inside area
of the filter.
4. Install the air cleaner cover and secure the latches
(Figure 37).
5. Install the air cleaner into the clamp and secure it with
the previously removed bolt
34
(Figure 36).