Adjusting The Belt Guides; Controls System Maintenance; Adjusting The Reverse-Stop Rod - Toro 74311TE Operator's Manual

Figure 59
1. Pump drive belt
2. Pump
3. Idler
7. Install the PTO belts as stated in
Belts (page 46).

Adjusting the Belt Guides

1. Stop the machine and move the speed-control lever
to the N position.
EUTRAL
2. Disengage the PTO, engage the parking brake, shut off
the engine, and wait for all moving parts to stop.
3. Engage the PTO lever.
4. Adjust belt guides as shown in
Figure 60
1. 3 mm (1/8 inch)
2. 11 mm (7/16 inch)
3. 3 mm (1/8 inch) Clearance 6. 8 mm (5/16 inch)
4. Pump
5. Idler
6. Engine
Replacing the PTO
Figure 60.
4. Rotate wireform guide to
center belts in guide.
5. 6 mm (1/4 inch)
Controls System
Maintenance
Adjusting the Reverse-Stop
Rod
1. Stop the machine and move the speed-control lever
to the N
EUTRAL
2. Disengage the PTO, engage the parking brake, shut off
the engine, and wait for all moving parts to stop.
3. Check the movement of the steering levers as follows:
•
If the levers move slightly forward up to 3 mm
(1/8 inch) then no adjustment is necessary.
•
If the levers do not move, then proceed with the
following steps:
A. Unlatch the seat and flip up the seat up or
remove the seat frame assembly (with the seat
attached) to obtain a clear view of the steering
control shaft to complete this adjustment.
B. Place the speed-control lever in the N
position.
C. Release the parking brake.
D. Slightly adjust the length of the rod by
loosening the jam nut and by rotating the rod.
1. Parking brake
2. Nut
3. Steering lever
E. Engage the parking brake and check the
steering levers.
Repeat steps
(1/8 inch) movement is achieved.
F. Install the seat frame assembly, if removed in
step A.
47
position.
Figure 61
4. Speed-control lever
5. Clevis pin and stop rod
C through E until up to 3 mm
EUTRAL