Opening The Access Covers; Greasing The Traction Unit - Toro 22303 Operator's Manual

If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the negative battery cable before you do any
maintenance.

Opening the Access Covers

Removing the Front Access Cover
1. Raise the loader arms and install the cylinder locks;
refer to Using the Cylinder Locks,
page 19.
Note: In the case that you need to remove the front access
cover without raising the loader arms, be very careful not
to damage the cover or hydraulic hoses as you maneuver
the cover out from under the arms.
2. Stop the engine and remove the key.
3. Release the two locking tabs (Fig. 20).
4. Pull the cover off of the traction unit (Fig. 20).
1
2
Figure 20
1. Front access cover
5. When finished, replace the front access cover and
secure it with the two locking tabs.
Opening the Rear Access Cover
1. Stop the engine and remove the key.
Caution
m–4595
2. Locking tabs
23
2. Release the two locking tabs on top of the rear access
cover (Fig. 21).
3. Grasping the handle, pull the cover up and back to
swing it open (Fig. 21).
Figure 21
1. Rear access cover
4. When finished, close the rear access cover by
swinging it up and seating it in place. Secure it with
the two locking tabs.

Greasing the Traction Unit

Grease all pivot joints every 8 operating hours and
immediately after every washing.
Grease Type: General-purpose grease.
1. Lower the loader arms and stop the engine. Remove
the key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting
(Fig 22 and 23).
2
1
2. Locking tabs