Figure 65
1. Fan belt
2. Idler pulley
Controls System
Maintenance
Adjusting Accelerator Pedal
1. Position vehicle on level surface, stop engine and
engage the parking brake.
2. Adjust ball joint on accelerator cable (Figure 66) to
allow .200"–.350" of clearance between accelerator
pedal arm and top of diamond tread floor plate
(Figure 67), when a 20 lb. force is applied to center
of pedal. Tighten locknut.
Note: Engine must not be running and return
spring must be attached.
The governor is preset at the factory to a
maximum engine speed of 3650 rpm. If the
speed is not correct, refer to the Workman
Service Manual or contact your authorized Toro
Dealer/Distributor for assistance.
1. Accelerator cable
50
Figure 66
2. Ball joint