Inspect Tires; Front Wheel Toe - Toro 07360 Operator's Manual

Figure 56
1. Differential lock cable
2. Transaxle bracket
3. Adjust jam nuts to obtain .035 ± .025 inch gap
between spring hook and O.D. of hole in transaxle
lever.
4. Tighten jam nuts after adjustment has been attained.

Inspect Tires

Service Interval: Every 100 hours
Operating accidents, such as hitting curbs, can damage a
tire or rim and also disrupt wheel alignment, so inspect
tire condition after an accident.

Front Wheel Toe

Service Interval: Every 400 hours/Yearly (whichever
comes first)
1. Measure center–to–center distance (at axle height) at
front and rear of steering tires. The measurement
must be .12 .12" greater at the front of the tire than
at the rear.
3. Spring
4. .035 ± .025 inch gap
1. Front of vehicle
2. .12 ± .12 inch greater than
rear of tire
2. Adjust the center–to–center distance as follows:
• On the right front wheel, loosen the jam nuts at
both ends of the tie rod (Figure 58).
1. Tie rod
• On the left front wheel, loosen the jam nuts at
both ends of the turn buckle (Figure 59).
• Rotate the tie rod and turnbuckle evenly to move
the front of the tire inward or outward to achieve
the center to center distances from front to back.
• Tighten tie rod and turnbuckle jam nuts when
the adjustment is correct.
• Check to make sure the tires turn an equal
amount to the right and to the left. If the tires do
not turn equally, refer to the Workman Service
Manual for the adjustment procedure
46
Figure 57
3. Center to center distance
Figure 58