Fuel System
Maintenance
Fuel System
Fuel Lines and Connections
Service Interval: Every 400 hours/Yearly (whichever
comes first)
Every 1,000 hours/Every 2 years
(whichever comes first)
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration,
damage, or loose connections.
Fuel Filter
Service Interval: Before each use or daily
Every 400 hours
Drain water or other contaminants from fuel filter/water
separator daily by loosening drain plug (Figure 51) on
filter canister. Tighten plug after draining.
1. Raise bed (if so equipped) and place safety support
on extended lift cylinder to hold up bed.
2. Place a clean container under fuel filters.
Figure 51
1. Fuel filter
3. Loosen R–clamps securing filter to frame.
4. Remove clamp securing fuel filter to fuel lines.
5. Install new fuel filter to fuel lines with clamps
previously removed. Filter must be mounted so
arrow points toward carburetor.
Electrical System
Maintenance
Fuses
The fuses for the machine's electrical system are located
under the center of the dash panel.
1. Fuses
43
Figure 52
Figure 53