Jacking Vehicle; Lubrication; Greasing Bearings And Bushings - Toro 07360 Operator's Manual

Jacking Vehicle

A vehicle on a jack may be unstable and slip off
of the jack, injuring anyone beneath it.
• Do not start the vehicle while the vehicle is
on a jack.
• Always remove the key from the switch
before getting off of the vehicle.
• Block the tires when the vehicle is on a jack.
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause
vehicle to slip off jack.
2. Do not work under vehicle without jack stands
supporting it. The vehicle could slip off jack, injuring
any one beneath it.
3. The jacking point at the front of the vehicle is under
the front center frame support and at the rear it is
under the axle tube.
4. When jacking up front of vehicle, always place a 2x4
block (or similar material) between jack and vehicle
frame.
Figure 39
1. Front jacking point
Figure 40

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal conditions,
lubricate all bearings and bushings after every 100 hours
of operation. More frequent lubrication is required if
used for heavy duty vehicle operations.
The grease fitting locations and quantities are: Steering
pitman arm (1) and Steering ball joint ends (2)
(Figure 41), Tie rod ends (4) (Figure 42), Front ball
joints (4) (Figure 42), Rear drive shafts (18) (Figure 43),
Pedal pivots (3) (Figure 44); Front pivot bushings (2)
(Figure 45) and Accelerator arm (1) (Figure 46).
Important: When greasing drive shaft universal
shaft bearing crosses, pump grease until it comes
out of all 4 cups at each cross.
1. Wipe grease fitting clean so foreign matter cannot be
forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
39
Figure 41