Fill Fuel Tank - Toro 07360 Operator's Manual

Figure 21
1. Dipstick
3. The engine uses any high-quality 10W30 detergent
oil having the American Petroleum Institute -API-
"service classification" CF or higher. Choose a
viscosity according to the table in Figure 22.
Figure 22
4. If oil level is low, remove filler cap and add enough
oil to raise level to FULL mark on dipstick.
Figure 23
1. Filler cap
Note: When adding oil, remove dipstick to allow
proper venting, pour oil slowly and check the level
often during this process. DO NOT OVERFILL.
Important: When adding engine oil or filling
oil, there must be clearance between the oil fill
device and the oil fill hole in the valve cover as
shown in Figure 24. This clearance is necessary
to permit venting when filling, which prevents
oil from overrunning into breather.
5. Install the dipstick firmly in place.
Important: Check level of oil every 8 operating
hours or daily. Change oil and filter initially after
the first 50 hours of operation, thereafter, change
oil and filter every 150 hours. However, change
oil more frequently when engine is operated in
extremely dusty or dirty conditions.
Note: After filling or changing oil, start and run the
engine at idle for 30 seconds. Shut engine off. Wait 30
seconds and check oil level. Add enough oil to raise
level to FULL mark on dipstick.

Fill Fuel Tank

Fuel tank capacity is approximately 7 gallons.
The Toro® Company Strongly Recommends The
Use Of Fresh, Clean, Unleaded Regular Grade
Gasoline In Toro Gasoline Powered Products.
Unleaded Gasoline Burns Cleaner, Extends
Engine Life, And Promotes Good Starting By
Reducing The Build–up of Combustion Chamber
Deposits. Minimum Octane Rating of 87.
24
Figure 24