Adjusting The Transport Height - Toro 04383 Operator's Manual

6. Slide the cutting unit under the pull frame while
hooking the lift hoop onto the lift arm.
7. Slide the sleeve back on each ball joint receiver and
hook the receiver onto the cutting unit ball stud
(Figure 17).
1. Pull link extension
2. Pull arm
8. Mount the basket onto the carrier frame.
9. Adjust the pull links until there is 1/16 to 1/8 in.
(2 to 3 mm) clearance between the lip of the basket
and the reel blades. Make sure the basket lips are
equidistant from the reel blades all the way across
the reel blades.
10. Assemble the mounting screws for the reel drive
motor to each cutting unit. Leave approximately
1/2 in. (13 mm) of the threads exposed on each
mounting screw (Figure 18).
Figure 17
3. Ball joint receiver
1. Screws
11. Using a hand pump grease gun, fill the cavity at the
end of the cutting unit with #2 general purpose
grease.
12. Coat the spline shaft of the motor with clean
grease and install the motor by rotating the motor
clockwise so the motor flanges clear the studs.
Rotate the motor counterclockwise until the flanges
are encircling the studs (Figure 18).
13. Tighten the mounting bolts (Figure 18).
9

Adjusting the Transport Height

No Parts Required
Procedure
Check the transport height (Figure 19 & Figure 20) and
adjust, if required.
1. Position the tractor on a level surface.
2. On cutting units equipped with a chain link or a
straight lift hook (Figure 19 & Figure 20, insets)
verify that the distance from the top of the carrier
frame adjusting screw to the back of the carrier
frame is 7/8 inch (22 mm). If the distance is not
7/8 inch (22 mm), proceed to step 4. If the cutting
unit is equipped with an offset lift link (Figure 21),
proceed to the next step.
20
Figure 18
2. Drive motor