Toro 04383 Operator's Manual page 21

1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
3. On cutting units equipped with a offset lift hook
(Figure 21, inset) verify that the distance from the
top of the carrier frame adjusting screw to the back
of the carrier frame is 1 inch (25 mm). If the distance
is not 1 inch (22 mm), proceed to step 4.
Figure 19
4. Chain link
5. 7/8 inch (22 mm)
Figure 20
4. Link hook
5. 7/8 inch (22 mm)
1. Transport plate
2. Adjusting screw
3. Transport plate mounting
screw
4. Loosen the transport plate mounting screws
(Figure 19, Figure 20 and Figure 21).
5. Raise the cutting units to the transport position.
Important: Do not raise the suspension to the
transport position when the reel motors are in
the holders in the machine frame. Damage to
the motors or hoses could result.
6. Ensure each carrier frame is at the same height from
the ground. If they are, proceed to step 8.
7. If the carrier frames are not at the same height,
loosen the jam nut on the carrier frame adjusting
screw (Figure 19, Figure 20 and Figure 21). Rotate
the screw outward to raise and inward to lower.
Tighten the jam nut after the proper height is
obtained.
8. Rotate the transport plate until it locks the pull
frame. Tighten the screws.
21
Figure 21
4. Offset lift hook
5. 1 inch (25 mm)