Lubrication; Greasing The Bearings And Bushings - Toro 31598 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Before each use or daily—Lubricate
castor arm bushings.
Every 50 hours—Lubricate all grease
fittings.
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If the machine is operated under normal
conditions, lubricate all bearings and bushings after
every 50 hours of operation or immediately after every
washing.
Note: The castor fork shaft bushings must be
lubricated before each use or daily
The grease fitting locations and quantities are:
Traction Unit
• Impact arms (2) (Figure 49)
• Front Deck Lift cylinder pivots (2) (Figure 49)
• Side Deck Lift cylinder pivots (2) (Figure 49)
• Steering cylinder ball joints (4) (Figure 50)
• Tie rod ball joints (2) (Figure 50)
• King pin bushings (2) (Figure 50)
• Rear axle pivot bushing (1) (Figure 51)
• Brake shaft pivot bearings (1) (Figure 52)
Figure 49
43