Greasing Machine; Product Overview; Controls - Toro 31598 Operator's Manual

2. Check the hydraulic fluid level before starting the
engine, refer to Checking the Hydraulic Fluid Level
in Hydraulic System Maintenance.
3. Check the cooling system before starting the engine;
refer to Checking the Cooling System in Cooling
System Maintenance.
7

Greasing Machine

No Parts Required
Procedure
Before the machine is operated, it must be greased
to ensure proper lubricating characteristics; refer to
Greasing the Bearings and Bushings procedure in
Lubrication in the Maintenance Section. Failure to
properly grease the machine will result in premature
failure of critical parts.

Product Overview

Controls

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
This machine produces sound levels in excess of 85
dBA at the operators ear and can cause hearing loss
through extended periods of exposure.
Wear hearing protection when operating this
machine.
Traction Pedal
The traction pedal (Figure 10) controls forward and
reverse operation. Press the top of the pedal to move
forward and the bottom to move backward. Ground
speed depends on how far you press the pedal. For no
load, maximum ground speed, fully press the pedal while
the throttle is in the Hi idle position.
To stop, reduce your foot pressure on the traction pedal
and allow it to return to the center position.
Brake Pedals
Two foot pedals (Figure 10) operate individual wheel
brakes for turning assistance, parking, and to aid in
obtaining better side hill traction. A latch connects the
pedals for parking brake operation and transport.
Pedal Locking Latch
The pedal locking latch (Figure 10) connects the pedals
together to engage the parking brake.
Tilt Steering Lever
Press the lever (Figure 10) down to tilt the steering
wheel to the desired position. Then release the lever to
lock the adjustment.
Turn Signal Switch
Press the left side of the turn signal switch (Figure 10)
to activate the left turn signal and the right side of
the switch to activate the right turn signal. The center
position is off.
Hi-Lo Speed Switch
Press the front of the switch (Figure 10) to select high
speed range. Press the rear of the switch to select
low speed range. The machine must be stationary or
19