Battery Care; Jump Starting / Battery Charging; Recalibrate Traction Pedal - Toro 31598 Operator's Manual

The cab fuses are located in the fuse box on the cab
headliner (Figure 70).
1. Cab fuse box

Battery Care

Service Interval: Every 50 hours—Check the battery
condition
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Important: Before welding on the machine,
disconnect the negative cable from the battery to
prevent damage to the electrical system. Also, the
engine, InfoCenter and machine controllers must
be disconnected before welding on the machine.
Figure 69
Figure 70
2. Fuses
Note: Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge
slowly. To clean the battery, wash the entire case with
a solution of baking soda and water. Rinse with clear
water. Coat the battery posts and cable connectors with
Grafo 112X (skin-over) grease (Toro Part No. 505-47)
or petroleum jelly to prevent corrosion.
Jump Starting / Battery
Charging
If the machine needs to be jump started or the batteries
need to be charged, the alternate positive post can be
used instead of the positive battery post (Figure 68).
The alternate positive post is located in the front of the
power center console (Figure 67).

Recalibrate Traction Pedal

Service Interval: Every 1,000 hours—Recalibrate
traction pedal
Contact your local Toro distributor or refer to the Toro
Service Manual for the assistance.
51