Safety And Instructional Decals - Toro 31598 Operator's Manual

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of
potential danger. Replace any decal that is damaged or lost.
1. Warning—disengage the PTO then raise the deck.
2. No step
3. Traction control pedal
4. Forward
5. Reverse
1. Disengage the power
take-off (PTO)
2. Engage the power take-off
(PTO).
3. Read the Operators
Manual.
114-0849
114-0134
4. Engine—stop
5. Engine—run/preheat
6. Engine—start
1. Read the Operators Manual; to start the engine, move the
traction pedal to Neutral, apply the brake, move the throttle
switch to low, turn the ignition key to Preheat. When the
Wait to Start Advisory clears on the Info Center then turn
the ignition key to Start.
2. Read the Operators Manual; to stop the engine, move the
throttle lever to slow, disengage the PTO, set the parking
brake, wait 5 minutes, turn the ignition key to Stop, and
remove the key; read the Operators Manual.
3. Read the Operators Manual.
4. To engage the PTO, pull up on the PTO switch.
5. To disengage the PTO, push down on the PTO switch.
6. To switch the transmission to high speed, fully raise the
attachments and switch the speed control to High.
1. Tilt steering lever
1. Raise cutting units—left
2. Raise cutting
units—center
9
114-0846
114-0845
2. Horn
114-0135
3. Raise cutting units—right