Toro UTV500AAC00000 Setup Instructions page 4

2. Raise the cargo box; then while holding the rear
ROPS, remove the screws securing the ROPS.
Loosely secure the ROPS in the correct position
using Allen Head Screws and new Nyloc Nuts. Do
not tighten at this time. Repeat for the front ROPS.
3. Place the Top X-brace into position between the
front and rear tubes and secure with eight Cap
Screws (installed from the top) and eight Zinc
Nyloc Nuts. Tighten to 47 N-m (35 ft-lb).
4. Secure the seat back to the rear ROPS tube with the
two cap screws. Tighten to 11 N-m (8 ft-lb).
4
UTV-068
5. Secure the bottom (middle) of the rear canopy tube
to the center support using two M6 Torx Screws.
Tighten to 11 N-m (8 ft-lb). Connect the brakelight/
taillight harness to the main harness.
UTV-148
6. Tighten the front and rear tubes (from step 2) to 47
N-m (35 ft-lb). Ensure the flats of the nuts engage
the recesses of the ROPS tubes when tightened.
UTV-070
TC022A
TC030A
TC027
TC029