Deluxe hard cab doors, these door kits are intended to be used on the following cab: workman md series cab 07328, sliding/solid window door kit (8 pages)
Page 1
Form No. 3412-977 Rev A Canopy Kit Workman ® MD/MDX/MDE Utility Vehicle Model No. 07324 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal115-7670 115-7670 1. Crushing hazard, rollover—read the Operator’s Manual; ROPS must be installed for effective rollover protection;...
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. – No parts required Prepare the machine. Rear support tube Left, rear support bracket Right, rear support bracket Bolt (5/16 x 2-3/4 inches) Bolt (5/16 x 2 inches) Bolt (5/16 x 1-3/4 inches) Flat washer (5/16 inch)
Installing the Canopy B. Loosely install the rear tube and support-bracket assemblies to the machine using 8 bolts (5/16 x 1. If your machine is equipped with a rollover prtection 1 inch) and 8 flange nuts (5/16 inch) as shown system (ROPS), you do not need to install a rear Figure support tube;...
Page 5
3. Locate the existing bracket mounted to the cross tube 5. For 2016 and After Models only, secure the canopy and under the right side of the dash, and remove the support to the dash support as follows: bracket under the dash (Figure A.
Page 6
6. Remove the rear bolt and nut that secure the dash to 11. Secure the canopy to the rear support frame as follows: the front frame support on the left side of the machine A. If your machine does not have a ROPS, secure the (Figure canopy to the rear support tube using 2 screws (5/16 x 2 inches), 2 washers (5/16 inch), and 2...