Tire Inflation Pressure; Wheel Lug Nuts - Toro UTV500AAC00000 Setup Instructions

2. Connect the red terminal lead from the charger to the
positive terminal of the battery; then connect the
black terminal lead of the charger to the negative ter-
minal of the battery.
3. Plug the charger into a 110-volt electrical outlet.
4. Charge the battery for a minimum of five full hours
at a rate of 10% of the battery amp-hour rating for
optimal battery performance and battery life (ex: 30
AH battery should be charged at 3.0 amps).
NOTE: If the battery becomes hot to the touch,
stop charging. Resume after it has cooled.
5. Once the battery has reached full charge (typically
13.5 volts), unplug the charger from the 110-volt
electrical outlet and disconnect the charging leads.
6. Allow the battery to sit for 2 hours before installing
in the vehicle.
Installing Battery
NOTE: The battery box is under the seat on the
operator's side. To access the box, remove the
seat and pry off the battery compartment cover;
then remove the thumb screw securing the battery
box cover and lift the cover to access the battery.
1. Route the battery cables into the battery compartment.
2. Install the battery; then connect the battery cables
(positive cable first) as shown. Tighten securely.
NOTE: When installing the battery into a vehicle,
coat the battery terminals with a light coat of
grease to minimize battery terminal corrosion and
then cover with the terminal boot if provided.
2
NOTE: Loss of battery charge may be caused by
ambient temperature, ignition OFF current draw,
corroded terminals, self-discharge, or other fac-
tors. Maintenance charging is required to keep the
battery at a "fully-charged" state.
TIRES
This vehicle is equipped with low-pressure tubeless
tires. Do not under any circumstances substitute tires of
a different type or size.

TIRE INFLATION PRESSURE

Operating this vehicle with improper or uneven tire
inflation pressure is hazardous. Always maintain
proper tire inflation pressure.
Front and rear tire inflation pressure should be 110 kPa
(16 psi) (UTV500) or 138 kPa (20.0 psi) (UTV700).
A low-pressure gauge is provided in the tool kit to mea-
sure the air pressure in the tires. Check the air pressure
in all tires before use of the vehicle.

WHEEL LUG NUTS

PR943A
Using a crisscross pattern, tighten the wheel nuts in 27 N-
m (20 ft-lb) increments to the final torque shown below.
Steel Wheel
Aluminum Wheel (Black Nuts)
Aluminum Wheel (Chrome Nuts)
TC019
Using an impact wrench could result in incorrect
torque which could damage the wheel or hub studs.
! WARNING
54 N-m (40 ft-lb)
80 N-m (60 ft-lb)
108 N-m (80 ft-lb)
CAUTION
PR942
PR941A