Toro UTV500AAC00000 Setup Instructions page 10

3. Repeat procedure twenty times.
! WARNING
Using the Operator's Manual as a guide, instruct the
customer on the proper use, care, burnishing proce-
dure (when brake pads are new), and maintenance of
the hydraulic brake system.
TRANSPORTING
NOTE: When transporting the vehicle, make sure
the vehicle is in park.
Inform the owner/operator that this vehicle must be
transported in its normal operating position (on all four
wheels) and secured with hold-down straps in the
proper areas. Shown is the minimum number of hold-
down straps to be used.
CAUTION
If using additional hold-down straps in any other
areas, care must be taken not to damage the vehicle.
10
Use extreme caution when operating a machine on a
ramp.
Ensure that the ROPS will clear the top of an
enclosed trailer.
Use only a full-width ramp; do not use individual
ramps for each side of the machine.
Do not exceed a 15-degree angle between the ramp
and the ground or between the ramp and the trailer
or truck.
Ensure the length of ramp is at least four times (4X)
as long as the height of the trailer or truck bed to the
ground. This will ensure that ramp angle does not
exceed 15-degrees on flat ground.
Avoid sudden acceleration or deceleration while
driving the machine on a ramp as this could cause a
loss of control or a tip-over situation.
PR075A
PR073A
! WARNING
TC028