Advertisement
Available languages
Available languages
C. Install one end of a clear hose onto the REAR
bleed screw and direct the other end into a con-
tainer; then while holding slight pressure on the
brake pedal, open the bleed screw and watch for
air bubbles. Close the bleed screw before
releasing the brake pedal. Repeat this procedure
until no air bubbles are present.
NOTE: During the bleeding procedure, watch the
reservoir very closely to make sure there is always
a sufficient amount of brake fluid. If the fluid level
gets low in the reservoir, refill the reservoir before
the bleeding procedure is continued.
D. Repeat step C until the brake pedal is firm.
E. At this point, perform step B, C, and D on the
FRONT RIGHT bleed screw; then move to the
FRONT LEFT bleed screws and follow the same
procedure.
4. Carefully check the entire hydraulic brake system
that all hose connections are tight, the bleed screws
are tight, and no leakage is present.
5. Make sure to burnish the brake pads during the test ride.
CHECKING THROTTLE CABLE
ADJUSTMENT
1. Check cable free-play by grasping the cable at the
top of the accelerator pedal and lightly pulling rear-
ward to remove slack. Free-play should be 1-2 mm
(0.040-0.080 in.).
2. Depress the accelerator pedal completely and pull
rearward on the cable end. There should not be any
free-play and the tension sleeve should not be com-
pressed.
3. To adjust the throttle cable, remove the throttle arm
cover on the throttle body; then loosen the two
adjuster nuts and adjust for proper free-play.
PR080A
4. Tighten the jam nut securely.
CHECKING ENGINE/
TRANSMISSION OIL LEVEL
NOTE: Inspect the area around the drain plug
(under the vehicle) and oil filter (front of the
engine) for leaks.
NOTE: To access the oil filter, remove the seat.
PR708A
Remove the screws securing the seat back and
remove the seat back; then remove the screws
securing the seat base and remove the seat base.
PR709A
TC020A
PR078A
7
Advertisement
