System Configuration - Hitachi Compute Blade 2000 User Manual

 System configuration
The following functions are available in the System Configuration screen.
Changes the LP ID, virtual NIC system number or administrative path.

Changes the IP address of LPAR manager or ServerConductor/Blade Server

Manager (BSM).
Configure the TCP port of the virtual COM console.

Change LPAR manager operating modes.

+---------------------------------------------------(14) Error Event Detected --+

|+- System Configuration -----------+-----------------------------------------+|

||
|| LP ID LP_192168020
||
|| LP IP Address 192.168.0.20
|| Subnet Mask 255.255.255.0 (3)|
|| Default Gateway 0.0.0.0
||
|| BSM1 IP Address 192.168.0.168 (5)| LP CLI1 IP Address
|| BSM2 IP Address 0.0.0.0
|| BSM3 IP Address 0.0.0.0
|| BSM4 IP Address 0.0.0.0
|| BSM1 Alert Port 20079
|| BSM2 Alert Port 20079
|| BSM3 Alert Port 20079
|| BSM4 Alert Port 20079
||
|| Management Path Default
|| VNIC System No:
|+----------------------------------+-----------------------------------------+|
|
+------------------------------------------------------------------------------+
|(13) F10:Update System Config
+------------------------------------------------------------------------------+
The following table describes each item on this screen.
# Title Official Name
(1) LP ID LPAR manager
identifier
(2) LP IP Address LPAR manager
IP address
(3) Subnet Mask Subnet mask
(4) Default Default gateway Sets the IP address of the Default Gateway.
Gateway
(5) BSM1~4 IP BSM1~4 IP
Address addresses
|
(1)| Alert Language
| Virtual Console Port 20801
(2)| LP Operating Mode
(4)|
|
| LP CLI2 IP Address
| LP CLI3 IP Address
| LP CLI4 IP Address
(6)| LP CLI5 IP Address
| LP CLI6 IP Address
| LP CLI7 IP Address
| LP CLI8 IP Address
|
(7)|
1 (8)|
Description
Sets the ID that identifies LPAR manager
Numbers, in which periods are omitted from the
LPAR manager IP address, are reflected as the
initial value following "LP_".
Make sure to set the new LPAR manager IP
address from the default. Otherwise, you cannot
go to another screen.
Make sure to set the new Subnet Mask from the
default. Otherwise, you cannot go to another
screen.
Sets the BSM IP addresses.
Sets IP address for a server blade on which
ServerConductor/Blade Server Manager (BSM),
HvmSh command, and HvmGetPerf command
operate.
When LPAR manager is started, the System
Manager 1~4 IP Addresses, which are set to the
management module, are applied as the initial
values.
1220
||
Japanese (9) ||
(10) ||
Standard(11) ||
||
||
||
0.0.0.0 (12) ||
0.0.0.0 ||
0.0.0.0 ||
0.0.0.0 ||
0.0.0.0 ||
0.0.0.0 ||
0.0.0.0 ||
0.0.0.0 ||
||
||
||
|
Esc:Menu |
Initial Value
LP_0000
0.0.0.0
255.255.255.
255
0.0.0.0
-