Check Device - Canon imageFORMULA P-215 Service Manual

CHAPTER 5 TROUBLESHOOTING
b. Motor
Checks the operation of the feed motor.
Select a resolution, a reading mode and
direction, then select [Start] to make the
motor turn at the speed that meets the con-
dition. Select [Stop] to stop the motor.
Start
/Stop
Resolution
Figure 5-226
c. CIS unit LED
When the corresponding LED button is
selected, the LED lights. Make sure to open
the upper unit fully before selecting the
button. Select the button again to turn off the
LED.
Figure 5-227
5-14
Gray Forward
/Color /Reverse
COPYRIGHT © CANON ELECTRONICS INC. 2011

9. Check Device

This mode displays versions of the main
body firmware and the internal devices of
this machine. The serial number is also
displayed and set.
On the service screen, select [Check
Device] to display the [Check Device]
screen.
Figure 5-228
• [MAIN]
Main body firmware
• [MCON]
Motor controller
Note: Version of the main body firmware can
also be confirmed on the user's driver
screen.
Serial number data is saved on the
control PCB. If this PCB is replaced, enter
the serial number shown on the rating label
at the bottom of the main body and select
"Set" on the right side.
CANON P-215 FIRST EDITION