CHAPTER 3 DISASSEMBLY & ASSEMBLY
2. Top Cover
1) Remove the upper unit [whole].
(Page 3-5)
2) Remove 2 screws
M2.5x6). Push out the end of the shaft
of the front roller (follower) and remove it.
At this time, 2 rollers
Figure 3-204
3) Remove the separation pad. While ex-
tending 5 pairs of the fitting parts
out side in order from the end side, remove
the upper cover on the rear side.
Note: The lock shaft, coil spring for the lock
shaft and entrance guide for card can
be removed when the upper cover is
removed.
Figure 3-205
Notes on assembling
After assembling the upper cover, be sure
to fasten the 2 screws.
3-6
1
(self-tapping, FH
2
3
are also removed.
1
to the
COPYRIGHT © CANON ELECTRONICS INC. 2011
3. Registration Roller [follower]
1) Remove the top cover.
(Page 3-6)
2) Remove the start switch PCB
base. Hold the registration roller on the
rear side with hand and unhook 2 pairs of
the fitting parts
plate, remove 2 registration rollers
shaft
4
and 2 springs
Figure 3-206
Notes on assembling
Bring the flat part at the center of the shaft
into contact with the end surface of the
springs.
Figure 3-207
1
from the
2
of the shaft pushing
3
, the
5
.
CANON P-215 FIRST EDITION