Base Unit; Control Pcb - Canon imageFORMULA P-215 Service Manual

III. BASE UNIT

1. Control PCB

1) Remove the rear cover.
(Page 3-4)
2) Remove the upper unit.
(Page 3-5)
3) Remove the 2 cables
the control PCB
1
(M3x4) and while escaping the control
3
PCB from the fitting parts
control PCB.
Note: Capacitors are mounted on the rear
side of the place [A] indicated by the
broken line. While disassembling, pick
the control PCB without hitting of the
capacitors.
Figure 3-301
COPYRIGHT © CANON ELECTRONICS INC. 2011
connected with
2
. And remove 3 screws
, remove the
4
CANON P-215 FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
4) Pull the switch slide plate
switch.
Figure 3-302
Notes on assembling
Before installing the PCB, install the switch
slide plate on the PCB.
1 out from the
3-9