External Parts; Bottom Cover; Operation Section Cover - Canon imageFORMULA P-208 Service Manual With Parts Catalog

I. EXTERNAL PARTS

1. Bottom Cover

1) Remove 7 screws
M2.5x6), insert a tool with a thin and flat tip
into the central hole
parts, and remove the bottom cover
Figure 3-101
Notes on assembling
Since the hole
1
tighten the screw from this position.
Figure 3-102
After tightening the screw, push in the
bottom cover until the fitting parts
hooked.
COPYRIGHT © CANON ELECTRONICS INC. 2012
1 (self-tapping, BH
2 , unhook the fitting
3 .
is used for positioning,
2
CANON P-208 FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY

2. Operation Section Cover

1) Remove the control PCB.
(Page 3-10)
2) Remove 1 screw
M2.5x6) and slide the operation section
cover downward. Since there are fitting
2
parts for the main body, slide the cover
strongly and slowly.
Note: The two detection levers
button
tached. The two detection levers should
be removed so that they are not lost
during work.
Notes on assembling
Do not get FPC or FFC caught when as-
sembling the operation section cover.
is
(self-tapping, BH
1
3
and the pickup tray are de-
4
Figure 3-103
, the start
3-1