Table of Contents
Advertisement
Many PTZ Domes on One Serial Communications Line
Configuring PTZ
Driver (name)
Bossware
Honeywell fixed camera 9600
Intellibus
Javelin 308
Document 800-07766V1 Rev A
02/11
2.
Set DIP switch 5-8 to ON, on each ACUIX camera. Set the Camera Address using
rotary switches (SW1 to SW4) on the PCB at the base of the dome. Do not use the
same Camera Address on two or more domes connected to the same bus.
3.
Connect the ACUIX cameras to a port on the Rapid Eye LT DVR.
4.
Notify the Multi SA of the number of the port used on the Rapid Eye LT DVR and the
Camera Address used for each ACUIX camera.
You can connect up to 8 domes on one communication line connected to the Multi-Media
LT DVR. Terminate the communication input(s) of the last dome in the chain. Leave other
domes un-terminated.
HD6/KD6/KD6i Domes
The HD6 / KD6 / KD6i domes cannot share the same serial communications line with other
makes and models of domes.
Consistent Port Attributes
Honeywell recommends that if domes are to share a serial communications line, installers
should select domes that:
•
Function at the same settings for: Baud Rate, Data Bits, Parity, and Stop Bits.
•
Use the same PTZ drivers.
Caution
Domes that require different PTZ drivers may not function as expected if
they are installed on the same port/serial communications line.
Use the View application to run a maintenance session. Use the Video tab to configure PTZ
settings. Multi-Media LT DVRs support the PTZ domes listed in
site can support many types of PTZ software drivers at the same time. Refer to the
Eye™ Multi-Media Digital Video Recorder System Administrator
enable a PTZ dome.
Table 5-3
PTZ Drivers for Controllers and Domes
a
Baud rate
19200
38400
9600
Rapid Eye™ LT DVR Installation Guide
Table
Guide, for procedures to
Support for (dome/controller/PIT device)
PIT device, to which domes are connected
Honeywell HCU484
ACUIX camera
Javelin 308 Controller
5-3. A Multi-Media LT
Rapid
53
Advertisement
Table of Contents
