Honeywell Tuxedo Touch Wi-Fi User Manual page 32

Using the Security System (cont'd)
3. When the system is armed for Away and Maximum mode, you will hear steady beeps then rapid
beeping during the last 10 seconds of Exit Delay.
4. For CP-01 installations, Maximum Mode cannot be used.
How to Arm Multiple Partitions
Note: Some systems may not have multiple partitions and the "Arm Multi-Partitions" option may not
be available. In addition, your code must be authorized to arm multiple partitions.
Press the SECURITY and Arm Multi-Partition icons. Select the appropriate arming
mode, enter the User Code authorized to access other partition(s) and highlight the partition from the
list on the screen or select ALL to arm all partitions listed. When done, press OK.
When exit delay time expires, the screen displays "Armed."
Notes:
1. A user may have access to some or all of the available partitions.
2. If the user code is accepted, the system displays the partitions that the user has access to.
3. If any zones are bypassed, a "Faulted Zones" ( ) icon is displayed on this screen.
How to Display Faulted Zones
If the system shows the "Not Ready Fault" message, it means a zone or zones are open (faulted). Zones
must be bypassed before you can arm the system. To display the open zone(s), do the following:
Press the SECURITY and FAULTED ZONES
icons. A listing of faulted and/or bypassed zones
is displayed. As applicable, take corrective action such as closing a window or door to correct the fault.
If the fault cannot be corrected, you may choose to bypass a zone by highlighting it and then pressing
the BYPASS SELECTED
icon.
To bypass all zones, press the Bypass All icon; to Refresh Data, press
.
The Distressed Zones icon is displayed when a zone is distressed. Distressed Zones icons include
Alarm , Troubles , Faults Bypass Zones , Low Battery , and All
, .
26