Removing Z-Wave Devices - Honeywell Tuxedo Touch Wi-Fi User Manual

Using Z-Wave Devices and Scenes (cont'd)
2. At the Tuxedo:
a) To verify activation, press the Back icon and wait 30 seconds. Press the Refresh
new device is displayed.
The keypad displays a series of messages:
Editing Z-Wave Device Names
To edit a device name, do the following:
1. Press the Automation
Management" screen.
2. Highlight the device name and press the Edit Name
3. On the "Data Entry" keyboard, press the
GO.

Removing Z-Wave Devices

Notes:
The Remove Device icon clears the node from the keypad and resets device to the default
•
setting.
To remove a defective device, or if the device is not removed, refer to the "Z-Wave
•
Troubleshooting" section.
When removing the door lock, the user code associated with the door lock remains in the
•
system. If needed refer to the control panel Installation Instructions on how to remove this
user code.
Honeywell is not responsible for property damages due to improper setting of the thermostat
•
modes.
Light, switch, outlet module or door lock module
1. At the Tuxedo:
a) Press the Automation
Management" screen.
b) Highlight the device name and press the Remove Device
2. At the Device Module:
a) Press the Function Key to remove the device from the keypad.
"Please press *function key on device"
"Adding Controller Unit"
"Adding Slave Unit"
"Device added successfully"
and Z-Wave Setup
in the device name field and enter a new name; press
and Z-Wave Setup
19
icons to display the "Z-Wave Device
icon.
icons to display the "Z-Wave Device
icon.
icon; the