Honeywell Tuxedo Touch Wi-Fi User Manual page 14

1. Select Safe Mode and then press Apply.
2. Press the OK icon.
3. To exit, press the safe mode bar and press Yes to return to Normal Mode.
While in the Safe Mode, the Home screen displays the Security, Panic, and Message Icon. A
•
message !SAFE MODE! Is displayed at the lower left side of the screen.
Tuxedo resets and restarts in the Safe Mode.
•
In the rare event that Tuxedo cannot successfully communicate in its graphic mode with the control
panel, the Safe Mode is a backup mode that ensures that you can communicate with your system.
In this mode, the keypad operates much like a standard non-graphic keypad so that you can control
your system until the problem is corrected.
If this situation occurs, Tuxedo presents you with a message of
and requests a
Mode?"
Mode. If you answer with
times of receiving no response, Tuxedo enters the Safe Mode automatically.
Note: Use care when providing the "Yes" or "No" response. Pressing the screen outside the prescribed
area may cause the background to come to the front. If this occurs, the Yes/No message that
disappeared times-out in 30 seconds even though it is not visible. Then Tuxedo resets into the
Normal Mode (or Safe Mode if this is the third time that the warning message appeared).
Note that this is a limited mode of operation. While in this mode:
You can use the Security icon to access the Console Emulation Mode of operation to try to
•
clear your faults, disarm the system, or enter additional Alpha Keypad commands specified in
your panel User Guide. You can perform almost all functions that you can perform from a
standard non-graphic alpha keypad.
You can press the "Panic" key and generate Emergency Messages as defined in the panel's
•
home partition for this keypad.
The Armed and Ready LEDs on the front of the keypad indicates Tuxedo's home partition
•
status. The Message LED (on models with Voice feature) or Trouble LED (on models without
Voice feature) is not active in the Safe Mode.
The Chime mode functions in the Safe Mode, however, you do not have Voice (system status
•
messages), Voice Chime (announcements) or Message capability (if set to default "Master").
Z-Wave Scenes do not function in Safe Mode.
•
When an alarm occurs in the Safe Mode, it is displayed on the Console mode screen only and
•
is not shown on the Home screen.
The Slide Show feature does not start automatically in Safe Mode.
•
About the System (cont'd)
or response. If you answer with
"Yes" "No"
Tuxedo tries to communicate with the panel again. After 3 consecutive
"No,"
"Problems detected. Start Keypad in Safe
"Yes,"
8
Tuxedo enters into the Safe