Placing A Call - Cisco TelePresence System Quick Set C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20 Administrator guide
Contents Introduction Web interface Advanced settings Password protection Appendices Contact us

Placing a call

You can use the Call Control page of the web interface to
initiate a call.
NOTE: Even if the web interface is used to initiate the call it
is the video system (display, microphones and loudspeakers)
that is used for the call; not the PC running the web interface.
Calling someone
Enter one or more characters in the address input field until
the name you want to call appears in the dynamic search list
or, enter the complete name or number. Then press Dial.
Press End all to disconnect the call.
Sharing contents
Select a Presentation Source from the drop down list, and
press the Start Presentation button.
Normally a PC is used as presentation source, but other
options may be available depending on your system setup.
To stop the content sharing, press the Stop Presentation
button that becomes visible while sharing.
Address input field
Call Control
D14637.08 Profile C20 and Quick Set C20 Administrator Guide TC5.1, February 2012.
19 www.cisco.com
Copyright © 2010-2012 Cisco Systems, Inc. All rights reserved.