Dell 3333dn Service Manual page 70

Fax error log codes (Continued)
Error code
888
889
88A
901
902
903
904
905
906
907
908
A00
A01
A02
A03
A04
F00
2-34
Service Manual
Description
Failure to transmit training successfully
at 2400 bps in V27 terminal modulation
scheme.
Failed to connect at the minimum
speed supported by the MFP.
Failed to connect using V.34
modulation scheme.
No fax tones detected from remote
end.
No dial tone detected.
Busy tone detected.
Hardware error detected.
A timeout occurred after dialing the
number and waiting for a response.
Fax cancelled by user.
Modem detected a digital line
connection.
Phone line was disconnected
Received request for unsupported
function from remote fax device.
Received request for unsupported
image width from remote fax device.
Received request for unsupported
image resolution from remote fax
device.
Received request for unsupported
compression type from remote fax
device.
Received request for unsupported
image length from remote fax device.
Unknown error occurred.
Action
• Adjust "Transmit Level".
• Check line quality.
• Adjust "Transmit Level".
• Incompatible connection.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
• Check by enabling 'Behind a PABX'
setting.
• Check phone line.
• Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See "Modem / fax card service check"
on page 2-63.
Check with remote end if successive
attempts fail.
No action needed.
Verify the MFP is connected to an analog
line. See"Fax transmission service
check" on page 2-64.
Restore phone line connection.
No action needed.
No action needed.
No action needed.
No action needed.
No action needed.
No action needed.