Dell 3333dn Service Manual page 51

User status and attendance messages (Continued)
User primary message
Load Manual
<type> <size>
Paper Changes Needed
PJL OP Message
PJL Seed Message
PJL ST Message
Remove Paper ADF
Remove Paper
Standard Bin
Restore Held Jobs. Go/
Stop?
Securely Clearing Disk
Space
Unsupported USB
Device, Please Remove
Unsupported USB Hub,
please remove
Unsupported Disk
34 Short Paper
Printer does not detect media meeting the description <type> and <size> in the
single sheet feeder (manual feeder).
The following actions can be taken:
• Load paper and the job continues.
• press Select ( ), and choose an alternate source for media.
• Cancel the current job.
Change or load new media.
Try one or more of the following:
• press Select ( ) to clear the message, and continue printing.
• Wait for the message to clear.
This posts when there is paper detected in the ADF upon POR or when the cover
is closed (or any other situation that re-inits the scanner). Message clears when
paper is removed.
The standard output bin is full or nearly full. Remove the media from the bin.
Held jobs were found on disk after a power on/off reset. Restoring will make these
jobs available. Jobs may also be restored at a later time by turning off and
restarting the printer.
The following actions can be taken:
• Restore
• Do not restore
• More information
This message appears when all blocks of the disk are cleared.
Remove the unrecognized device from the USB port on the front of the printer.
Remove the unrecognized USB hub/device from the USB port on the front of the
printer.
Remove the unsupported disk before continuing.
)
• press Select ( to clear the message and continue printing.
The printer does not automatically reprint the page that prompted the
message.
• Check tray length and width guides to ensure paper is properly fitted in the tray.
• Make sure the print job is requesting the correct size of paper.
• Adjust the Paper Size setting for the size paper you are using.
If MP Feeder Size is set to Universal, make sure the paper is large enough for
the formatted data.
• Cancel the current job.
Explanation
Diagnostics information
2-15