Dell 3333dn Service Manual page 52

User status and attendance messages (Continued)
User primary message
35 RES Save Off
Deficient Memory
37 Insufficient Collation
Area
37 Insufficient memory
for flash defragment
operation
38 Memory Full
2-16
Service Manual
This message displays when the printer lacks sufficient memory to enable
Resource Save. This message usually indicates the user has allocated too much
memory for one or more of the printer link buffers; however, modification of other
printer settings which affect the amount of available memory may also create this
condition. If restoration of Resource Save is required after this message is
received, the customer should install additional memory or set each link buffer to
Auto. Once all link buffers are returned to Auto, you should exit the menu to
activate the link buffer changes. Once the printer returns to the Ready state, you
can enable Resource Save and go back and modify the link buffers again. Note
the reduction of available memory to the link buffers when Resource Save has
been enabled, and compare it to the memory available when Resource Save is
disabled.
• press Select ( ) to disable Resource Save and continue printing.
To enable Resource Save after you get this message:
- Make sure the link buffers are set to Auto, then exit the menus to activate
the link buffer changes.
- When Ready is displayed, enable Resource Save.
• Install additional memory.
This message is displayed when the printer memory used to store pages is too full
to collate the print job.
The following actions can be taken:
• press Select ( ) to print the portion of the job already stored, and begin
collating the rest of the job.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions are available.
- Cancel Job
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
This message is displayed when insufficient printer memory is available to perform
Flash Memory Defragment operation.
This message appears prior to the actual start of the defragment operation.
press Select ( ) to stop the defragment operation.
To perform the defragment operation, you can:
• Delete fonts, macros, and other data in RAM.
• Install additional printer memory.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions are available using the Busy/Waiting Menu:
- Cancel Job
- Reset Printer
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
This message is displayed when the printer is processing an incoming job and
there is not enough memory available to continue processing the job.
The following actions can be taken:
• Determine how to make more memory available to your print job by:
- Deleting fonts, macros and other data in RAM.
- Simplify your print job.
- Install additional memory
• press Select ( ) to clear the message and continue printing.
The job may not print correctly.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
Explanation