Scanner Manual Registration - Dell 3333dn Service Manual

To adjust the flatbed edge erase setting, perform the following steps:
1. Touch FB Edge Erase from the Configuration Menu.
touch-screen.
2. Touch to increase the value or
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.

Scanner Manual Registration

This item is used to manually register the flatbed and ADF on the MFP's scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register a Duplex ADF, perform the following steps:
1.
In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2.
Touch Scanner Manual Registration.
3.
Touch the Print Quick Test Page menu item.
4.
To view and adjust the duplex ADF front side registration, place the quick test page face up into the ADF.
5.
Touch Copy Quick Test.
6.
After the quick test page copies, touch ADF Front.
7.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
8.
Press Submit to accept the value.
9.
Verify the changes by placing the print quick test page face up and touching Copy Quick Test.
10.
Repeat steps 6, 7,and 8 as needed.
11.
To view and adjust the duplex ADF backside registration, place the quick test page face down up into the
ADF, and touch Copy Quick Test.
12.
After the quick test page copies, touch ADF Back.
13.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
14.
Press Submit to accept the value.
15.
Verify the changes by placing the print quick test page face down and touching Copy Quick Test.
16.
Repeat steps 13, 14,and 15 as needed.
To manually register the flatbed, perform the following steps:
1.
In the Configuration Menu, touch the Scanner Manual Registration menu item.
2.
Touch the Print Quick Test Page menu item.
3.
To view and adjust the flatbed registration, place the quick test page into the flatbed.
4.
Touch the Copy Quick Test Page item.
5.
After the quick test page copies, touch Flatbed.
6.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
7.
Touch Submit to accept the value.
8.
Place the print quick test page on the flatbed and touch Copy Quick Test.
9.
Repeat steps 5 and 6 as needed.
To exit RESGISTRATION press BACK
3-8
Service Manual
to decrease the value.
or to increase or decrease the settings value for horizontal adjust and top margin.
or to increase or decrease the settings value for horizontal adjust and top margin.
or to increase or decrease the settings value for the left or top margin.
[setting's current value]
or STOP .
appears on the