Cisco FastHub 100 series Installation Manual page 73

rpsappb Page 11 Monday, September 14, 1998 8:19 AM
Table B-2 Error Descriptions and LED Status (Continued)
RPS LED Status Condition
Two or more of the
Cisco RPS LEDs are
amber.
Reading Error Messages on Cisco 2600 and 3600 Series Routers
Error Indicators, Descriptions, and Solutions
How to Correct Error:
Check the temperature of the room that the Cisco RPS is located in.
Correct the room temperature if it is above 40
and rear of the Cisco RPS to make sure they are clear of any obstructions.
If the error message persists, the Cisco RPS needs to be replaced.
Console Message Issued Upon Correction of Error:
When an external device console screen displays the Cisco IOS software
prompt (routername > or routername #)
THERMAL condition is now normal"
When an external device console screen displays the ROMMON prompt
(rommon #>) no console message is issued when the error is corrected.
SNMP Trap Issued Upon Correction of Error:
ciscoEnvMonRedundantSupplyNotification is generated. The varbinds
included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState. The value of ciscoEnvMonSupplyState will be
normal.
Console Error Message:
When an external device console screen displays the Cisco IOS software
prompt (routername > or routername #)
failure with the redundant power systems; please resolve
problems immediately."
The Cisco IOS software checks the condition once every 30 seconds. If
the condition still exists, the error message redisplays.
Note It is not a multiple failure when two or more DC Output Modules
have failed.
When an external device console screen displays the ROMMON prompt
(rommon #>)
The message will vary depending on the mix of failures.
Description of Error:
The Cisco RPS has two or more failures of any of the previous types.
o
C. Check the front bezel
"Redundant Power Supply
"There is more than one
Troubleshooting the Cisco RPS B-11