rps4 Page 15 Monday, September 14, 1998 8:19 AM
Step 4
Figure 4-15
Step 5
Step 6
On the rear panel of the Cisco RPS, connect an AC power cable to either or both
of the power connectors. Use cable locks—included with the Cisco RPS—to
lock the cables in place. (See Figure 4-15.)
Connecting the AC Power Cables to the Cisco RPS
Plug the other end of the Cisco RPS AC power cable into a grounded AC power
outlet at your site.
If you are using the redundant-with-reboot configuration, plug the switch AC
power cord into a grounded AC power outlet now.
Connecting Switches
Cable locks
Connecting Cables 4-15