Displaying Status - Cisco FastHub 100 series Installation Manual

rpsappb Page 4 Monday, September 14, 1998 8:19 AM

Displaying Status

Displaying Status
Cisco IOS Release 11.2(7)P and later releases support status messages for Cisco 3600
series routers using the Cisco RPS. Cisco IOS Release 11.3(2) and later releases support
status messages for Cisco 2600 series routers using the Cisco RPS. Status messages are not
supported for the FastHub series 100, FastHub series 200, FastHub series 300 100BaseT
hubs, HP 10BaseT Hub-16M 10BaseT hub, the Catalyst 1900 series, Catalyst 2820 series,
Catalyst 2900 series XL switches, Cisco 2500 series and 4000 series routers, and the
Cisco MC3810 multiservice concentrator.
The show env command (available in Cisco IOS Releases 11.2 (7) and later releases)
provides an environmental status of the Cisco RPS. An example display follows:
router# show env
Power Supply:
Redundant Power supply is present.
Thermal status is normal.
AC status is normal.
DC status is normal.
Board Temperature:
Warning: Board overtemperature condition detected.
Caution
If thermal shutdown occurred because the cooling-system failed or ambient temperature
rose above normal operating limits, a thermal warning will display on the router console
and an SNMP trap will be sent before shutdown.
B-4 Cisco Redundant Power System Hardware Installation Guide
If the Cisco RPS gets too hot, it shuts down to prevent damage to its components.